Spring Corner Clamp

Corner clamp to assist in assembling parts at a 90 degree angle, such as model structure walls. Depress the plunger, position the parts, and release the plunger. The parts are held tightly at a 90 degree angle by spring pressure. Accommodates material up to 1/4 inch thick. Clamp sides are approximately 2 1/2 inches long (3 inches long measured from outside corner). Clamp jaws are approximately 1 1/4 inches long (approximately 1 9/16 inches from inside corner). Clamp side and jaw are approximately 1/2 inch high. Color may vary from that shown. Produced by Ric Case. This item may be produced on-demand incurring delays from ordering to shipping.